Wheels for Land Rover Defender

The new Defender is one of the best-looking trucks on the road, and it only gets better with the right wheels. Every wheel on this page is 5x120 — the pattern on the 2020 and newer Defender — with the 72.6mm hub bore these trucks need. Bolt them on and go.

Defenders get built two ways: clean street builds and full overland rigs. For the street look, Vossen and Forgestar make Defender fitments that are straight-up gorgeous. For overland, Method and KMC in 18s give you the sidewall you want when the pavement ends.

Offset on the Defender is tight because of the brakes and suspension — stick between +20 and +40mm and you'll clear everything. Go wider than 9.5 inches and you'll want to stay closer to +20.

These trucks are more capable than most owners will ever test. Set it up with a small lift, 33s, and the right wheels, and you've got an overland rig that'll go anywhere.

Fitment

  • Bolt pattern: 5x120
  • Fits: 2020–present Land Rover Defender (L663) — 90, 110 & 130
  • Hub bore: 72.6mm
  • Offset: +20 to +40mm (stay near +20 on wheels wider than 9.5")
  • ⚠️ Classic Defenders: pre-2020 models are 5x165.1 — this page is 2020+ L663 only.

Shop by brand

FAQ

What's the bolt pattern on a Land Rover Defender?

The 2020 and newer Defender (L663) runs a 5x120 bolt pattern with a 72.6mm hub bore — 90, 110, and 130 models included.

Will these wheels fit my classic Defender?

No. Classic pre-2020 Defenders use a 5x165.1 bolt pattern, so nothing on this page will fit them. This page is for 2020 and newer (L663) trucks only.

What offset should I run on my Defender?

Stick between +20 and +40mm. The Defender's brakes and suspension don't leave much room, and this range clears everything. If you go wider than 9.5 inches, stay closer to +20mm.

Can I run 18s for overlanding?

Yes — Method and KMC make 18-inch 5x120 options that give you the sidewall you want when the pavement ends. It's the go-to setup for overland Defenders.

What's the hub bore on a Defender?

72.6mm. Every wheel on this page matches the factory bore, so they mount hub-centric with no rings or vibration.

Want a second set of eyes on your setup before you buy? Call 405-627-1620 and we'll confirm fitment before you order.